Scheduler

You are viewing this page in read-only mode. Task management requires admin access.
# Task Script Target Affected Schedule Last / Next On Actions
No scheduled tasks yet — click "+ New task" to create one. No tasks match the current filter.

Scheduler · Tasks
← back to Scheduler
Name *
Task type
SNMP Walk
Polls the switch(es) selected in Target below (set Asset type = switch, or pick a specific switch). Reads MAC / port / VLAN + switch info over SNMP. No script needed.
Check Point Sync
Reads host objects (with DHCP reservation) and users from the firewall(s) selected in Target below — set Asset type = firewall for every firewall in scope (optionally narrowed by Customer), or pick a specific firewall. Links them to matching computers and people as Check Point accounts. Read-only on the device. No script needed.
M365 connector *
No connectors visible — M365 connectors are managed by admins in Settings ▸ M365 Connectors.
Description
Recipe *
Trigger
This task runs only when an alert rule links to it — attach it in Alerts ▸ Rules ▸ On fire.
Schedule *
Fires in: …
Alert-trigger options
Run on
Cooldown (minutes)
Min gap between runs (0 = none).
Max runs / hour
Then stop & notify.
Verify after (seconds)
If the alert is still open this long after the task ran, run it again. 0 = run once only.
Max retries
Extra runs allowed per alert. Acknowledged alerts are never retried.
Customer scope
Asset type
Specific asset (optional — overrides type + filters)
Attribute filters (AND across rows)
Run options
Execution
Credential
Sudo
Protocol
Timeout (sec)
Affected assets
Calculating…
No assets match this task yet.